Henry G. Morse, President
William Sellers, Vice President
William F. Sellers, Secretary
William H. Connell, Treasurer
F.W. Heisler, Purchasing Agent
Edge Moor Bridge Works
P.O. Willmington, Del.  Edge Moor, Del.
Steel Eye Bars
[Drawing of Bar]
[Dimensions of Bar]
NOTES
Edge Moor Standard Eye Bars are Hydraulic Forged without the addition of extraneous metal, and without
buckles or welds, and are guaranteed under the conditions given in the above table to oev e l op value of the bar when tested to destruction
The heads on Stanard Eye Bars are finished of the same thickness "B" as the body of the bar Eye Bars with heads varying from the Standard either in thickness or diameter will be supplied at an additional COST-
the increased thickness of the head over that of the body of the bar is limited to 8 of an inch. We contract only for finished Eye Bars, that is with the eyes bored at distances apart from
centre to centre. ask equired, and of right diameter to fit the size pin to be used.
Unless otherwise specified,Steel of the following duality will be used.
Ultimate Strength,60,000 to 68,000 Lbs per square inch, Elastic Limit, not less than one half the tensile strength
Elongation, from it to 20 percent,The Elongation to be measured after breaking, on an original length of ten times the shortest dimensions of the test piece. Reduction of Area, 34-to-40 percent.
To all bars, one inch Thick and under, add 1 1/2" To the above adds.